Wasp-barcode WLS9600 Product Reference Guide Manuel d'utilisateur télécharger pdf (Page 26)

WLS9600

Reading Configuration Barcodes

You must first enable your reader to read barcodes in order to use this

section. If you have not done this, go to

Setup, starting on page 5

and

complete the appropria

te procedure.

To program features:

1. Scan the ENTER/EXIT PROGRAMMING barcode, available at the top of each pro-

gramming page, when applicable.

2. Scan the barcode to set the desired programming feature. You may need to cover unused

barcod

es on the

page, and possibly the facing page, to ensure that the reader reads only the

barcode you intend to scan.

3. If additional input parameters are needed, go to Appendix D, Keypad, and scan the appro-

priate characters from the keypad.

Additional information about many features can be found in the “Refer-

ences” chapter.

If you make a mistake before the last character, scan the CANCEL barcode to

abor

t and not sa

ve the entry string. You can then start again at the begin-

ning.

4. Complete the programming sequence by scanning the ENTER/EXIT PROGRAM-

MING barcode to exit Programming Mode.

For detailed descriptions, programming information and exam

ples for setting selected

configuration items, see References, starting on page 231.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 305 306

Pas de commentaire

Wasp-barcode WLS9600 Product Reference Guide Manuel d'utilisateur Page 26