Wasp-barcode WLS9600 Product Reference Guide Manuel d'utilisateur télécharger pdf (Page 25)

Product Reference Guide 15

Chapter 3

Configuration Using Barcodes

This and following sections provide programming barcodes to configure your reader by

changing the default settings. For details about additional methods of programming, see

Configuration Methods on page 3.

You must first enable your reader to read barcodes in order to use this

section. If you have not done this, go to

Setup, starting on page 5

and

complete the appropria

te procedure.

Configuration Parameters

Once the reader is set up, you can change the default parameters to meet your application needs.

Refer to "Standard Defaults" starting on page 265 for initial configuration in order to set the

default values and select the interface for your application.

The following configuration parameters are divided into logical

groups, making it easy to find

the desired function based on its reference group.

Interface Configuration:

• "RS-232 ONLY Interface" on page 19

• "RS-232/USB-Com Interfaces" on page 24

• "Keyboard Interface" on page 33

• "USB-OEM Interface" on page 45

• "Wand Emulation Interface" on page 47

Parameters common to all interface applications:

• "Data Format" on page 51 gives options to control the messages sent to the Host system.

• "Reading Parameters" on page 65 control various operating modes and indicators status

functioning.

Symbology-specific parameters:

• "Code Selection" on page 77 provides configuration of a personalized mix of codes, code

families and their options.

Model-specific parameters:

• "Laser Features" on page 227 provides options specific to laser models.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 305 306

Pas de commentaire

Wasp-barcode WLS9600 Product Reference Guide Manuel d'utilisateur Page 25