Wasp-barcode WDI4600 2D Product Reference Guide Manuel d'utilisateur télécharger pdf (Page 246)

References

236

WDI4600

Motion Features

Motionless Timeout

This setting specifies the amount of time that the reader takes to assume that it is in a motionless

condition. The range for this setting is from 500 msec to 25.5 seconds, in 100 millisecond

increments.

Follow these instructions to set this feature.

1. Determine the desired setting.

2. Pad the result with leading zeroes to yield three digits. For example: 0.5 = 0005 = 00, 5 =

50,

20 = 200, etc.

3. Go to page 204 and scan the ENTER/EXIT PROGRAMMING MODE barcode to

enter Programming Mode.

4. Scan the barcode: SELECT MOTIONLESS TIMEOUT SETTING.

5. Scan the appropriate three digits from the keypad in Appendix D, Keypad representing

the duration which was determined in the steps above. You will hear a two-beep indica-

tion after the last character.

If you make a mistake before the last character, scan the CANCEL barcode to

abort and not save the entry string. You can then start again at the begin-

ning.

6. Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Programming

Mode.

This completes the procedure. See Table 45 for examples of how to set this feature.

Table 45. Motionless Timeout Setting Examples

STEP ACTION

EXAMPLES

1 Desired Setting

500ms 1 sec. 10 sec 9,900ms (9.9 sec.)

Divide by 100 (and pad with

leading zer

oes to yield two

digits)

005 010 100 250

3 Scan ENTER/EXIT PROGRAMMING MODE

4 Scan SELECT MOTIONLESS TIMEOUT SETTING

Scan Two Characters From

Appendix D, Keypad

‘0’, ‘0’ and ‘5’ ‘0’, ‘1’ and ‘0’ ‘ 1 ’, ‘ 0 ’, a n d ‘ 0 ’ ‘2’, ‘5’, and ‘0’

6 Scan ENTER/EXIT PROGRAMMING MODE

1 2 ... 241 242 243 244 245 246 247 248 249 250 251 ... 283 284

Pas de commentaire

Wasp-barcode WDI4600 2D Product Reference Guide Manuel d'utilisateur Page 246