Wasp-barcode WDI4600 2D Product Reference Guide Manuel d'utilisateur télécharger pdf (Page 200)

Enter/Exit Programming Mode Micro PDF417

190

WDI4600

Micro PDF417 Length Control

This feature specifies either variable length decoding or fixed length decoding for this

symbology.

Variable Length:

For variable length decoding, a minimum and maximum length may be set.

Fixed Length:

For fixed length decoding, two different lengths may be set.

DEFAULT

$CMILC00(CR)

Micro PDF417 Length Control = Variable Length

$CMILC01(CR)

Micro PDF417 Length Control = Fixed Length

Micro PDF417 Set Length 1

Specifies one of the barcode lengths for Micro PDF417 Length Control. Length 1 is the

minimum label length if in Variable Length Mode, or the first fixed length if in Fixed Length

Mode. Length includ

es the barcode’s data characters only. Characters can be set from 0001 to

0366 characters (pad with zeroes) in increments of 01. Any value greater than 0366 will be

considered to be 0366.

See page 217 for detailed instructions on setting this feature.

$CMIL1

Select Micro PDF417 Length 1 Setting

To configure this feature, scan the ENTER/EXIT PRO-

GRAMMING MODE barcode above, then the barcode at

ft followed by the digits from the Alphanumeric char-

acters in

Appendix D, Keypad representing your

desired character(s). End by scanning the ENTER/EXIT

rcode again.

Make a mistake? Scan the CANCEL barcode to abort and

not sa

ve the entry string. You can then start again at the

beginning.

CANCEL

DEFAULT

0001 = Length 1 is 1 Character

1 2 ... 195 196 197 198 199 200 201 202 203 204 205 ... 283 284

Pas de commentaire

Wasp-barcode WDI4600 2D Product Reference Guide Manuel d'utilisateur Page 200